x-fabric home

IPTV Quality Measurement

Network counters show whether links are up. An IPTV quality measurement shows whether a given channel reaches the living room intact, channel by channel, from the subscriber's point of view.

Why Measure IPTV Quality?

Compressed video is fragile because one lost packet can damage several frames that depend on each other. Managed IPTV is usually delivered as multicast, so a fault at one replication point affects every viewer behind it.

What Shapes the Viewing Experience

Viewing Experience
AspectTypical cause of problems
Picture and sound qualityBitrate, codec and encoder settings at the head end
Transmission impairments (blocking, freezes)Packet loss, loss bursts, jitter
Channel change time (zapping)Multicast join delay, key frame interval, set-top box buffering
Channel availabilityMissing or interrupted multicast streams, head end outages

Channel Change and IGMP

When a viewer switches channels, the set-top box leaves one multicast group and joins another, using IGMP (IGMPv3, IETF RFC 3376; MLD in IPv6 networks). The zapping time the viewer perceives is the sum of several steps.

  1. Join Request

    The set-top box joins the new multicast group.

  2. Stream Starts

    The network starts to deliver the new stream.

  3. Next Key Frame

    Playback can only start at the next key frame, a fully encoded picture in the stream.

  4. Decoder Buffering

    The set-top box fills its buffer before it shows the picture.

A test head that joins channels the way a set-top box does measures the network's share of this delay and detects channels that do not arrive at all. ITU-T G.1080 lists channel zapping time among the quality-of-experience requirements for IPTV.

Transport Stream and Network Metrics

Transport streams and IP delivery are checked against guidelines and metrics such as these.

ETSI TR 101 290
Measurement guidelines for MPEG-2 transport streams, grouped by priority: priority 1 checks whether a stream can be decoded at all (synchronisation, continuity, essential tables), priority 2 adds recommended continuous checks such as timing and CRC errors, priority 3 covers application-dependent checks. Written for DVB broadcasting, it is widely applied to transport streams carried over IP.
Media Delivery Index (MDI), IETF RFC 4445
Condenses IP delivery into two figures: the Delay Factor, which reflects jitter and the buffering a receiver needs, and the Media Loss Rate, which counts lost or out-of-order media packets.
IP metrics
Packet loss, loss bursts and jitter, measured per channel, help locate a problem in the head end, the core, or the access network.

From Network Metrics to Perceived Quality

Requirements and quality models relate network behaviour to what the viewer experiences.

ITU-T G.1080
Defines user requirements independent of network architecture and transport protocol.
Broadband Forum TR-126
Describes quality-of-experience requirements for triple-play services and maps viewer expectations for video, voice and data to engineering targets.
ITU-T P.1201
A parametric, non-intrusive model (P.1201.2 for higher-resolution services such as IPTV) that estimates audio, video and audiovisual quality as a MOS from packet header information.
ITU-T P.1203
Addresses adaptive streaming over HTTP, as used by TV apps and OTT services, including the effect of quality switches and stalling.

What a Good Measurement Needs

The subscriber's location
Measure behind the same access as the subscriber.
The whole channel line-up
Rotate through all channels, since a channel missing in one region is invisible from the head end.
Continuity
Around the clock, including peak viewing hours and major live events.
Precise timing
Join and zapping delays are short, so timestamps must be accurate.
Context
Transport metrics locate a fault, quality models show what it means for the viewer, and a comparison with the head end separates source problems from transport problems.